sad day

funrider

Active member
Joined
Feb 4, 2009
Messages
129
Reaction score
29
Location
northern alb.
well just blew up my 08 summit 800 ptek 60 psi on one side and 120 on the other
any idea on how much to repair
checking options
 

rebel

Active VIP Member
Joined
Aug 25, 2008
Messages
30,723
Reaction score
50,526
Location
JNP
Depends on if you are going to rebuild or take it in.
 

Lem Lamb

Active VIP Member
Joined
Apr 5, 2010
Messages
3,575
Reaction score
6,448
Location
Lacombe AB
Probably cheaper too buy a running replacement sled of same year as either will save you funds when other parts are needed.

Only an idea as our group had all the same sleds with lots of spares if needed.

Lem
 

Giver800

Active VIP Member
Joined
Jan 12, 2015
Messages
182
Reaction score
143
Location
Airdrie
Really depends on your bottom end and if its good or not and if you can do the work yourself. If you are lucky and can reuse your bottom end then you could get away with doing a top end with jugs for about $1000 if you get parts from recreation supply in Saskatoon. They have good inventory and usually can get parts to you within 2 business days. If your bottom end is pooched you could be looking at about $2000 roughly if I had to guess. Others who know more may tell me I'm wrong though, but from what I know that would be my guess.
 

teeroy

Active VIP Member
Joined
Oct 7, 2007
Messages
9,093
Reaction score
14,059
Location
Roma, Alberta
well just blew up my 08 summit 800 ptek 60 psi on one side and 120 on the other
any idea on how much to repair
checking options
depends on what happened inside. hope you get lucky, unlike I was. ended up with a new shortblock for $3K
 

funrider

Active member
Joined
Feb 4, 2009
Messages
129
Reaction score
29
Location
northern alb.
sounds like it would need to be rebuild with checking all main components I don't have the knowledge but might have some help
thanks for advice guys
 

slededjr

Active VIP Member
Joined
Nov 25, 2011
Messages
1,577
Reaction score
1,972
Location
sherwood park
Can get a reman short block from Mots for $1800
Replate monoblock $450, Wossner Piston kit $350
Gasket kit $120
Isoflex grease $80
Either buy reman short block or do a complete tear down and rebuild. No sense half azzin it, Do crank seals and re pack bearings as well.
 

funrider

Active member
Joined
Feb 4, 2009
Messages
129
Reaction score
29
Location
northern alb.
3000 km, on the trail out it just shut down no oil or engine light thought it seized how quick it stopped pulled the recoil had more resistance hit the estart and it turned over then started ran rough for 100 meter shut down with temp light did this a couple more times to the trailer
 

treeboy

Active VIP Member
Joined
Nov 14, 2010
Messages
183
Reaction score
112
Location
The Monashee Mountains
I'd be checking the tolerance on the crank first before I'd do anything. There were a lot of 08 with out of spec cranks or close to out. You might be better off buying a short block.
 

team-x

Active VIP Member
Joined
Sep 4, 2012
Messages
228
Reaction score
129
Location
Edmonton
Like others have said, check the crank, and check the crank seals. Probably lost a seal, went lean, and burnt a piston. If you are lucky you might get away with a top end rebuild. I broke a piston and cracked both the top and bottom case when parts went flying so I needed a short block. If you go that route Tom over at Mott's is a great guy to deal with.
 
Top Bottom