A-arm differences between years of XM- interchangeable??

Team Pigeon · Dec 4, 2017

Gents,

Can I install RAS 2 lower a arms on my 2014 XM??

The 2016 fiche shows same numbers as 2014 BUT also has some different numbers which I think is the RAS 2 was part of the T3 lineup that was not offered on SP model sleds.

Thanks.
.

Bnorth · Dec 4, 2017

Team Pigeon said:
Gents,

Can I install RAS 2 lower a arms on my 2014 XM??

The 2016 fiche shows same numbers as 2014 BUT also has some different numbers which I think is the RAS 2 was part of the T3 lineup that was not offered on SP model sleds.

Thanks.
.

As long as it's a non-T3 sled it should have the same RAS 1 front end as your 2014. The RAS2 lower look the same except there is a slight curve in the rear tube right before it meets the S-module. Hope that helps.

Team Pigeon · Dec 4, 2017

So back to my question-- RAS 2 lowers won't fit into a RAS 1 sled?

Bnorth · Dec 4, 2017

Team Pigeon said:
So back to my question-- RAS 2 lowers won't fit into a RAS 1 sled?

Sure, just change everything else (uppers/spindles) too. The RAS2 creates a different caster angle.

tex78 · Dec 4, 2017

A hole ras2 kit is 1000, 2 lowers -2 uppers- tie rods - 2 front shocks

A ras2 lower will not work ( will bolt in but nothing will be the right angles) in a s36 14 xm as spindle is not the same, and tie rods are different if I recall

Team Pigeon · Dec 4, 2017

tex78 said:
A hole ras2 kit is 1000, 2 lowers -2 uppers- tie rods - 2 front shocks

A ras2 lower will not work ( will bolt in but nothing will be the right angles) in a s36 14 xm as spindle is not the same, and tie rods are different if I recall

YESSS thanks for the straight up answer!

A-arm differences between years of XM- interchangeable??

Team Pigeon

Active VIP Member

Bnorth

Active VIP Member

Team Pigeon

Active VIP Member

Bnorth

Active VIP Member

tex78

Active VIP Member

Team Pigeon

Active VIP Member

Similar threads