WRP Running boards from 2007 Summit

vodoo103

Active VIP Member
Joined
Jan 27, 2011
Messages
953
Reaction score
1,510
Location
Blindman River, Alberta
Anyone need a set of WRP running boards off my '07?
Located just outside of Red Deer.

IMG_5207.jpg


IMG_5206-1.jpg
 

NoBrakes!

Active VIP Member
Joined
Nov 13, 2011
Messages
6,002
Reaction score
11,802
Location
Edmonton
Has anyone tried these on an XP/XM? I have a buddy with a saggy XM rail that's looking for a cheap fix...
 

vodoo103

Active VIP Member
Joined
Jan 27, 2011
Messages
953
Reaction score
1,510
Location
Blindman River, Alberta
Has anyone tried these on an XP/XM? I have a buddy with a saggy XM rail that's looking for a cheap fix...

Tell him it will cost $80 to find out :d. These aren't perfectly flat either, but at least there is some proper material there instead of louvered 16 ga Aluminum.

I am not sure if the width is different, but would definitely take some modifications since the Rev chassis had the brake up on the chain case, and the XP's are where they started putting the brakes on the left side of lower drive shaft.
 
Last edited:

NoBrakes!

Active VIP Member
Joined
Nov 13, 2011
Messages
6,002
Reaction score
11,802
Location
Edmonton
Thanks again!

These will end up on buddies XM or a Phazer 500 project I'm throwing together.
 
Top Bottom