Getting check engine to and from riding area from staging area..

• Jan 18, 2021

• #1

fredw

Active VIP Member

Joined

Jan 15, 2010

Messages

3,317

Reaction score

3,586

Location

medicine hat

Been getting this check engine ses displaying this last weekend.. runs fine at elevation and no problem, then end of day coming back it shows again..

Would not think I’m the first having this, no code number with it, anyone else experience this, and any cure

Thanks

 

• Jan 18, 2021

• #2

snopro

Active VIP Member

Joined

Mar 3, 2009

Messages

101,974

Reaction score

90,877

Location

Milo,Alberta

call dealer. Plug it in

 

• Jan 18, 2021

• Thread starter
• #3

fredw

Active VIP Member

Joined

Jan 15, 2010

Messages

3,317

Reaction score

3,586

Location

medicine hat

I will get out the candoo software and pull it in memory, sounds like a rave valve conflict or something weird, does not effect performance from what I can see so far and only a few times a day

 

Last edited: Jan 19, 2021

• Jan 25, 2021

• #4

OOC ZigZag

Active VIP Member

Joined

May 12, 2010

Messages

1,581

Reaction score

1,385

Location

Calgary

RAV valves not sure where they are wanna sit lol. Had the same thing happening in McBride an Vale last week. When I run the throttle burping it nothing when I hold constant anywhere from 50k to 60km per/hr I get the check engine warning. Error code says RAV’s going in tomorrow an I’m betting it’s the servo motor.

 

• Jan 27, 2021

• #5

Dynamo^Joe

Active VIP Member

Joined

Aug 17, 2007

Messages

227

Reaction score

790

Location

Thunder Bay, Ontario

If you have an aftermarket brake handle (heated) then check the switch to see if there is melted snow around it. That will cause the dash to beep and engine code like 50 times. It will stop when you're going after running hard, the handle heats up. The switch gets snow on it, melts a bit, shut off, freezes with it on. If the beeper goes off, then "coast" down to stop, dont touch the brake handle. Coast to a stop and go check if the brake light is on.

 

• Jan 28, 2021

• #6

Teth-Air

Active VIP Member

Joined

Oct 16, 2008

Messages

3,751

Reaction score

7,966

Location

Calgary/Nelson

Dynamo^Joe said:

If you have an aftermarket brake handle (heated) then check the switch to see if there is melted snow around it. That will cause the dash to beep and engine code like 50 times. It will stop when you're going after running hard, the handle heats up. The switch gets snow on it, melts a bit, shut off, freezes with it on. If the beeper goes off, then "coast" down to stop, dont touch the brake handle. Coast to a stop and go check if the brake light is on.

Click to expand...

We have seen this with a non-heated aftermarket aluminum brake handle too.

 

• Feb 4, 2021

• #7

OOC ZigZag

Active VIP Member

Joined

May 12, 2010

Messages

1,581

Reaction score

1,385

Location

Calgary

Frayed RAV cable inside the controller. All better now.