GreyGhost
Active VIP Member
Maybe your rear wheels are bent? Not uncommon with these plastic ones
Random 850 questions.
- Thread starter skegpro
- Start date
Maybe your rear wheels are bent? Not uncommon with these plastic ones
GreyGhost
Active VIP Member
Hmmm my 17 does this once and awhile. It might not apply but do you have an aftermarket can? And any venting?? I have the race hood and took all the heat soaking foam out along with a GGB can. It will run horribly till it warm up
Bradvtown
Member
My 850 has the same worn rail cap but only one. May need to check the rear idlers as I bought it this fall and still haven't used it. Need snow bad.
- Thread starter
- #27
skegpro
Active VIP Member
What's the trick to getting this shaft out?
- Thread starter
- #28
skegpro
Active VIP Member
Got it.
- Thread starter
- #29
skegpro
Active VIP Member
Is it eating your slider anywhere?
Track seems pretty tight, not sure how much tighter a guy wants to go.
Had the sled up on the stand adjusted the rear axle till it tracked straight. Tension isn't quite uniform not. One axle is about 1/16th of an inch threaded in more.
Not sure what is more important uniform tension or alignment.....
jcjc1
Active VIP Member
pull one of the rubber wheels off it's bearing and then you'll need a puller to remove the bearing after removing it's circlip.
- Thread starter
- #31
skegpro
Active VIP Member
Got a little more scientific about track tension and alignment.
canuck5
Active VIP Member
Similar threads
