Exhaust can question

• Nov 25, 2018

• #1

Z

zeke800

Active member

Joined

Nov 9, 2010

Messages

32

Reaction score

13

Location

Canora

I noticed on the 19 model summit the exhaust probe is on the bottom. Just wondering how you can mount the probe on the top of an mbrp race can. The cord isn’t long enough. Any help would be a great thx.

 

• Nov 25, 2018

• #2

ferniesnow

I'm doo-ing it!

Joined

Dec 2, 2008

Messages

108,772

Reaction score

83,076

Location

beautiful, downtown Salmon Arm, BC

Dallas, I have TheThing cooker can and the temp probe is also on the top. I snipped the zip tie on the wire harness that goes to the temp probe and found it was long enough. Then I zip tied the temp probe harness so that it wouldn't fall down. Looks almost factory done!!

 

• Nov 25, 2018

• Thread starter
• #3

Z

zeke800

Active member

Joined

Nov 9, 2010

Messages

32

Reaction score

13

Location

Canora

Thx for the help

 

• Nov 25, 2018

• #4

P

pete gads

Active VIP Member

Joined

Feb 27, 2007

Messages

507

Reaction score

994

Location

calahoo, alberta

Hi i have a 2019 g4 and just put a ggb can on it. Same thing that the exshaust sensor is at top. Cut zip tie and where the connector is disconnect from holder clip and will have lot of lenght. The extra lenght zip tie to water pump line so wont touch pipe.