2019 Can heat sensor lower location
- Thread starter dooin800
- Start date
Caper11
Active VIP Member
Probably not, not yet anyway.
maxwell
Active VIP Member
they are all like that now
it was too easy to access before so they moved it. LOL
it was too easy to access before so they moved it. LOL
- Thread starter
- #5
Caper11
Active VIP Member
IMO I would be cautious putting a can on a 19 that was developed for a 17/18. That sensor got moved to a different part of the exhaust stream for a reason.
Kakwasledder
Active member
My mechanic assured me it wont make a difference where the probe is. I have an MBRP trail can and we cut the probe mount off and moved it approximately 90 degrees around and welded it back on. I hope it wont make a difference, I will probably take my stock can out the first ride just in case the I get a cel.
maxwell
Active VIP Member
you could leave that sensor dangling and put a plug in that hole your sled would run the same. Its main purpose is for the warmup mode function
dragonweld28
Supporting Vendor
The SSI Stainless can has no running issues with the probe relocated. I test fit one at Riverside. Have to remove the plastic clip on the chances cover and reroute the probe over to the side. On thing we did find is that the diameter of the probe increased from 17/18 and was bit tight getting it in there. Had to twist and push, but eventually was in and bolted tight.
Last edited:
Similar threads
