Jan 31, 2018 #1 A albertarmk86 New member Joined Jan 30, 2018 Messages 1 Reaction score 0 Location alberta Does anyone have a picture of the bleed screw/bolt on a 2011-13 rmk pro oil pump? I just did a fresh rebuild and there is air in the lines.
Does anyone have a picture of the bleed screw/bolt on a 2011-13 rmk pro oil pump? I just did a fresh rebuild and there is air in the lines.
Jan 31, 2018 #2 CatMan16 Active VIP Member Joined Nov 25, 2007 Messages 1,185 Reaction score 1,832 Location Red Deer Find the high point in the pump. Clean off the grim an the screw will be there.
Jan 31, 2018 #3 JMCX Active VIP Member Joined Dec 29, 2007 Messages 1,556 Reaction score 3,551 Location Calgary You could pull up on the rod at the throttle bodies while idling and it will pump the air out.
Jan 31, 2018 #4 Tchetek Active VIP Member Joined Nov 11, 2013 Messages 2,696 Reaction score 6,791 Location Alberta There is a about 10 mm bolt right in the middle of the pump facing the tunnel. Would be a hard place to take a picture without pulling the engine.
There is a about 10 mm bolt right in the middle of the pump facing the tunnel. Would be a hard place to take a picture without pulling the engine.
