2010 polaris 800 won't idle????

07grizzly

Member
Joined
May 14, 2009
Messages
16
Reaction score
2
Location
Canada
My sled idle's so low that the headlights and dash light will turn off and on and then it just shuts off. It runs find when I drive it or a give it a lil gas with the throttle but it won't idle on its own. Was wondering if anyone esle has had this problem or might know what is wrong.
 

magnet

Active VIP Member
Joined
Apr 29, 2008
Messages
5,364
Reaction score
1,391
Location
GSBA
My sled idle's so low that the headlights and dash light will turn off and on and then it just shuts off. It runs find when I drive it or a give it a lil gas with the throttle but it won't idle on its own. Was wondering if anyone esle has had this problem or might know what is wrong.
engine going out!!! first sign of it low comp.
or your idle screw has just backed out a bit
hopefully its the later one.
 

Rhodesie

Active VIP Member
Joined
Mar 11, 2010
Messages
1,995
Reaction score
6,327
Location
Medicine Hat, AB
My sled idle's so low that the headlights and dash light will turn off and on and then it just shuts off. It runs find when I drive it or a give it a lil gas with the throttle but it won't idle on its own. Was wondering if anyone esle has had this problem or might know what is wrong.
Stock or does it have v-force reeds in it?
 

07grizzly

Member
Joined
May 14, 2009
Messages
16
Reaction score
2
Location
Canada
the sled has slp heads, pipe, highflow intake, boysen rage cages and pcv runing the slp map. I'll have to do a compression test but the motor only has around 250 miles since the new cylinders, pistons, rings.
 

Rhodesie

Active VIP Member
Joined
Mar 11, 2010
Messages
1,995
Reaction score
6,327
Location
Medicine Hat, AB
the sled has slp heads, pipe, highflow intake, boysen rage cages and pcv runing the slp map. I'll have to do a compression test but the motor only has around 250 miles since the new cylinders, pistons, rings.
If it was poor compression or a vr it would run bad all the time, need to dig deeper, i would start by checking for broken or chipped reeds.
 

timbo

Active VIP Member
Joined
Dec 18, 2006
Messages
1,088
Reaction score
386
Location
edmonton
Sounds like the TPS (throttle positioning sensor) needs to be adjusted,might have been bumped doin the reeds.
 

07grizzly

Member
Joined
May 14, 2009
Messages
16
Reaction score
2
Location
Canada
Thanks for the info i'm gonna try a few things let you guys know what happens.
 

07grizzly

Member
Joined
May 14, 2009
Messages
16
Reaction score
2
Location
Canada
Reset the TPS on my PV5 didnt help, did a compression test 130 psi both sides. I took the top end out and the reeds found that the top reeds pedals on both reed cages are chip and cracked.
 
Top Bottom