ATACC installation

Highfly

Active VIP Member
Joined
Feb 23, 2012
Messages
1,628
Reaction score
2,004
Location
Airdrie
Wondering if anyone can help me. I'm installing an ATACC system on my daughters 600. I already have it on my 800 so will be using it for reference.
The only thing I'm not 100% clear on is do I keep the same jetting I have now and just add the system? I can't use the 800 for jetting reference as they are not the same.
 

Attachments

  • 20151027_103503.jpg
    20151027_103503.jpg
    98.2 KB · Views: 270

CatMan16

Active VIP Member
Joined
Nov 25, 2007
Messages
1,185
Reaction score
1,832
Location
Red Deer
You jet it for your lowest riding elevation. Also it should say in the instructions that you want to leave the small blue hose off the compensator until you are at the lowest elevation then connect it. I had one of those on my 800 mountain cat and I hauled it to revy and connected the hose in the parking lot of the hotel. Amazing how well those systems work my sled ran like it was fuel injected after I put it on.


Sent from my iPad using Tapatalk
 

250mark1

Active VIP Member
Joined
Dec 17, 2007
Messages
1,240
Reaction score
1,349
Location
blackfalds
We jetted the sleds for minus 30 and our home elevation as the warmer and or higher you get the Atacc will lean or richen out the mixture as needed
They worked great on the sleds we installed on worth every penny
if you have questions give holtzman a call the guy that invented actually answers the phone
 

Highfly

Active VIP Member
Joined
Feb 23, 2012
Messages
1,628
Reaction score
2,004
Location
Airdrie
Thx guys. I read through the instructions, says make sure jetting is done properly as they wont be heald responsible for engine damage. That had me a little spooked. I'll check what the jetting is now and look at the manual to see where it's at. I agree, the 800 runs soooo good with it. Looking forward to getting the 600 the same. Thx again.

Sent from my SM-N920W8 using Tapatalk
 
Top Bottom