Arm Candy A-Arm Braces

Teth-Air

Active VIP Member
Joined
Oct 16, 2008
Messages
3,733
Reaction score
7,909
Location
Calgary/Nelson
I have been asked if the Arm Candy Braces fit the 2019 RMK.

The Arm Candy Braces do fit the new 2019 AXYS RMK a-arms as confirmed with the installation on my personal sled last night

They do fit snug on the powder coated arms and they need to be taped into place with a non-marring dead blow hammer or a steel hammer and a chunk of 2x2 wood to protect the finish.

We have now sold out of the black anodized version but have more on order and should have them in 2 weeks.

The raw aluminum look good too as they tie in with the aluminum of the tie-rods. Stock is available for these.

The second question I have been getting is " are they even required with the new design?"

Polaris made these arms as weak as the original design but being slightly shorter they will have a little less leverage on them. Still if you catcha rock with the skag, they may fold. If they fold you may destroy your shock too. Also as it is a new design they may be hard to find and your season may be put on hold for a while. So better safe than sorry.

Again we did not have any reports of bulkhead damage while using these and we sold many. The arms still collapse on big hits just not the unnoticeable little hits.

$199 for the raw aluminum and $229 for the black anodized.
 

Attachments

  • 2018-11-05 14.59.49.jpg
    2018-11-05 14.59.49.jpg
    243.9 KB · Views: 223
  • 2018-11-05 14.59.59.jpg
    2018-11-05 14.59.59.jpg
    236.5 KB · Views: 215

Tchetek

Active VIP Member
Joined
Nov 11, 2013
Messages
2,680
Reaction score
6,698
Location
Alberta
Did you order the 36 front end, or can you adjust between 36 and 39 somehow?
 

Teth-Air

Active VIP Member
Joined
Oct 16, 2008
Messages
3,733
Reaction score
7,909
Location
Calgary/Nelson
Did you order the 36 front end, or can you adjust between 36 and 39 somehow?

The 2019's come with shorter a-arms than previous years. I believe they now have 37"-39" stance (going by memory), just move the ski bolt spacers. The Arm Candy Braces support the thin area of the lower arms (all years from 16-19)

If you want to narrow an earlier model the easiest way is to change the spindle to the offset design. can be seen here... http://www.sourceinnovations.ca/product-category/polaris/

We have 3 types. AXYS, ASSAULT and ProRide.

The nice thing is there is no changing tie-rods, shocks and a-arms. These also still provide full travel in the suspension as the shocks don't get shortened. 20 minute install, they are stronger than stock and they come with upgraded Oilite bushings.

Chris
 

Attachments

  • 2018-10-09 09.37.13.jpg
    2018-10-09 09.37.13.jpg
    159.7 KB · Views: 165
Last edited:
Top Bottom