Axys high beam and handle bar heaters stopped working

TJGDragon

Active member
Joined
Nov 5, 2009
Messages
28
Reaction score
8
Location
Gull Lake
Has anyone had there high beam and handle bar heaters quite at the same time? I tested the light plug with a tester and there is no power to the harness pin. Is there any fuses besides the 2 amp by the clutch? That fuse was ok.
 

dabensmiller

Active VIP Member
Joined
Nov 22, 2008
Messages
452
Reaction score
865
Location
DV/Sicamous
I would bet good money that the wiring plugged into the switches that are mounted on the console came loose. Pull back the plastic and take a look, i had it happen to me before.
 

TJGDragon

Active member
Joined
Nov 5, 2009
Messages
28
Reaction score
8
Location
Gull Lake
I checked to make sure of that to and everything is plugged in. If that plug was loose would the dims work?
 

d8grandpa

Active VIP Member
Joined
Apr 20, 2008
Messages
1,680
Reaction score
2,276
Location
Okotoks
The heaters and high beam don’t always work at idle also. Not enough voltage till engine is higher rpm.
 

TJGDragon

Active member
Joined
Nov 5, 2009
Messages
28
Reaction score
8
Location
Gull Lake
Ya I talked to the dealer and they said that it is probably the voltage regulator.
 

Couch

Active VIP Member
Joined
Apr 14, 2013
Messages
665
Reaction score
1,151
Location
Nl
Ya I talked to the dealer and they said that it is probably the voltage regulator.
That or the cheap switches! 3 decent switches and 7/8 more sealed connections can't add that much more to the original $
 

c_oke2000

Member
Joined
Feb 15, 2015
Messages
7
Reaction score
0
Location
Fort McMurray
Picked up my 18 pro, first ride out to valemount and hand warmers worked but high beams wouldn’t work at all. Just wondering if you had any luck rectifying your issue. Thanks
 

adamg

Active VIP Member
Joined
Mar 8, 2011
Messages
3,441
Reaction score
4,644
Location
S'toon,SK
Picked up my 18 pro, first ride out to valemount and hand warmers worked but high beams wouldn’t work at all. Just wondering if you had any luck rectifying your issue. Thanks

My sled was like that. The cables were not connected to the switch, or the connection 4" from the switch.
 

Bug

Member
Joined
Nov 14, 2006
Messages
13
Reaction score
7
It is the relay in frount of your oil tank. It is wraped inside the Velcro pouch. When you unplug it the connection will be rusted
 

TJGDragon

Active member
Joined
Nov 5, 2009
Messages
28
Reaction score
8
Location
Gull Lake
I played with all of the wiring and noticed it wouldn't work at idle. When I went for a ride everything worked so I asked the dealer and they said she to the electric oil pump when you are at idle it will shut down all the power to your aaccesories and all the power will go to your oil pump.
 
Top Bottom