Raising the bar

dodgeram18

Active member
Joined
Mar 16, 2010
Messages
75
Reaction score
48
Location
Shuswap, B.C.
I have been doing some research and it looks like a 4" bar riser is the most i can do before extending brake line, throttle cable, etc. Does anyone have any input or experience with this? can i fit a 5" riser block or am i stuck with 4"? I do not want to extend my cables, etc. thanks. (sled is 06 rmk 900)
 

powder junkie

Active VIP Member
Joined
Nov 18, 2008
Messages
787
Reaction score
527
Location
redwater, alberta, canada
I have been doing some research and it looks like a 4" bar riser is the most i can do before extending brake line, throttle cable, etc. Does anyone have any input or experience with this? can i fit a 5" riser block or am i stuck with 4"? I do not want to extend my cables, etc. thanks. (sled is 06 rmk 900)


4 sounds like alot. I had 2" and would be close if i had bars slid down (adjustable post) and turn. Then i swapped out stock bars and riser for pro taper bars which ended up bit taller than stock & 2" riser and i could only use bars in middle or slid up, as cables were to tight to slid bars down, but didnt matter to me for my riding.

if u ride wit bars all the way up (forward) then u mite fit 4-5" but i dunno
 

dodgeram18

Active member
Joined
Mar 16, 2010
Messages
75
Reaction score
48
Location
Shuswap, B.C.
Yeah I'm always riding with my post in the up most position. I will do all I can to get slack for the most rise I can do and every inch helps for control. If I can get away with 5" in a fixed upright only position I'll do that if I'm stuck with 4" I guess that will do.
 
Top Bottom