Recent content by STEVIE D

hey gary just wanted to thank you for all info i got that beast running yesterday between valves out an carb i put alil oil in cylinders an it cranked off after got hot stopped blowing oil an then changed oil an recranked an runs great so just wanted to tell you thanks for info ,,,,,,,,,,,,,,,,,,

hey gary i reset valves this weekend an recleaned carbs an put back together poored alil oil in each cylinder an it fired off but blowing oil an what lookes like fuel through vent hose from crankcase to airfilter housing , so what is up wiht that

Hey gary i took carbs off again an recleaned put back on after cked timing again an sprayed alil carb cleaner on plugs an in cyllinders an tryed to start again an it popped over for sec an then would not again so i am thinking possible carbs not synced correct are fuel issue , what you think

I used another comp tester just to ck an same thing , but like i said i am trying a few things this weekend , it is really hard when i work till 6 every nite an dark when get home , i have just weekend time an inbetween honey does for wife i test things , i tell you if my son would have not...

No i have not but i will this weekend i had to charge battery over night it was weak so no help there , but after i ck front cylinder to see if valve bent at stem i will go back to beginning if all is ok , an then i will ck comp again with good hot battery,,,,,,,,,,,,, dont have pull rope for me...

So do you think it is worth pulling head on front cylinder cause i pulled rear already an it is fine , i did pull cover an ck valves i did not pull head on front an ck for bent valve i can see valves movin as i spin over with wrench on pull rope bolt they seem to be open an closing as normal not...

I cked timin on cams yesterday that was on money so it cant be chain jumped if so timing would be off up top to ,correct , i will ck carbs again

I cked timing on cam this weekend an it is on the money i did not perform leak down test i am this week i have to get tool , i am at point where to me if chain jumped on inter shaft timing would be out on cams but they are ok so i will do leak down test an go from there , never had one whip on...

SO YOU THINKING VALVE NOT CLOSING ALL THE WAY ON MAYBE EXHAUST SIDE , U SUGGEST DOING LEAK TEST ON VALVES TO SEE IF LEAKING DOWN , ALSO WOULD IT RUN ON ONE CYLINDER LIKE IF BACK WAS SEALING OFF AN GOOD WOULD IT STILL START , ALSO WHEN I GOT IT TO START THAT ONE TIME BY SPRAYING CARB CLEANER IN...

It was running the same day an i heard it running alil bad an so i pulled carbs off found alil trash in front carb , put back together sprayed alil carb cleaner an tryed it , it fired off an so i finsihed putting it back together an it only started one time since , i find it hard to believe...

Garry how does decompressor work i cant get compression in either cylinder an i did not touch them i just cleaned carbs so i am wonderin if one of vacum lines is wrong so they want open to build compression in cylinder to start it

No but i read where they are famous for shearing timing gear pin an causing no comp on both cylinders which is what i also have so i think that might be the problem cause i have 0 compression on either cylinder ........

Thanks that is next step i am use to repairing honda an rebuilding them blindfolded this is whole different animal do you know if have to pull engine to get to front head off

:mad:I CLEANED ALL JETS AN IT IS GETTING FUEL JUST SPITS BACK THROUG CARBS LIKE VALVE NOT CLOSING

No tits but do you have an answer