Recent content by SCRUBZ

https://www.maxcelerationracing.com that combo wasn’t listed on his site but I messaged him and he set me up. Good guy fast shipping.

Just got this setup 10” alpha wheels and offset axle 380$ to my door!

^^^^X2

Blue pink primary black purple secondary

I don't think so... Got different springs and derlin washers as Chris suggested but I'm also running a 3 inch so you would have to talk to him on that?

I think it was 970$ call Chris at parkland motorsports 1 (780) 963-0080 great service!!

Gonna slid the cylinders back off to be certain... Any thoughts on reusing these base gaskets... They were both brand new???

Just talked to my buddy and I guess he over looked checking the gaps :frusty: thank god he did not get it all back together. The cylinder was torqued though should the base gaskets be replaced???

K thanks Chris we are going to throw it back together!

Just seems a little bit short. The gasket barely stays in place.

Just wondering if anyone has any experience installing this kit. We were putting one together yesterday and the dowel pins they supplied don't seem to be long enough to make it through both gaskets, cylinder shim and have enough there for the cylinders to be centered. As there was only about 1mm...

I used CR racing did two pros last year! Very nice!!!

I'm running one as well over 300 miles on my 14 and holding strong!

Powder coated mine no prob. Even drilled the end cap and ran some high stregth stainless rivets just in case.

Ya tunnel is wrapped with matte black vynyl to match hood and side panels