Recent content by revdog

What km did you stage at?And is there active logging going on?Thx.

The cast iron spinder broke one arm and hit the belt guard.Belt guard had tobe replaced but saved the machine. Was just driving down the trail at 30 mph.Sled had 2700 miles.Always clean my clutches and would check any cracks on the clutch. Wear the spider broke you would not have seen a crack.

2016 m8000 LTD stock other tan exhaust can and 21/49 gears.What weights are being used? Came with 61 gram weights.Spring is 85/225 most riding in valmount and Revy 7000 ft.

STOP apoligizing for the weather. It is was it is.:(

2016 M8000 what will be the noted differences if I change out the driven clutch spring from stock 180-240 to a 190-260 ? The machine is stock 153 3inch track with mbrp can and is geared up.RPM is at 8000-8100.

Had a bog in a M7 with half a tank of fuel.Fill the tank and the bog was gone. Removed the fuel pick up and found loose clamps on the pick lines.Reclamped and no more bog.

Can I use my 2013 primary clutch puller on a 2016 m8000 ?

Did the APV synthetic oil [blue] get updated to the AC C-TEC2 [green]? What oils have riders be using?

Got 4 repair tabs from mountainvalleymachine.com Have not installed them yet but made from aluminum should work fine.

Any way to repair a broken side panel tab?

Does Costco primium fuel contain any ethanol?Any reasons not to use it a sled?

Run your drill in reverse.It will make a cleaner hole.

Where does the snow get into these machines?What is my options to seal off to keep snow out of the intake?

Thanks!

What is the clutch bolt torque on 2000 summit 700 ?