Recent content by dwayne2960

Got a areo 53 charger with complete install for the M7, was running it on my 09 M8, but want to upgrade to the 2012, and the turbo is to small. $2200.00 boost werx controller, ovs clutching

yes same problem, 09 M8 53 aero turbo attitude box, played around with clutching and fuel pressure this last weekend. goes hard when it wants to! pulls hard the first 2 seconds thens lets off and goes again, if i'm in deep snow most times will bog at around 7500 rpm. installed lighter wieghts...

Are you running a new fuel pump with your turbo setup? if so you know what patr number it was? was there an adapter that you had to slip onto the bottom of the pump with a barb fitting?

As a volunteer for the local club in La Crete wondering how you are going to conduct pass checks? Would be great if we got some provincial help on policeing the trails!!All the best in collecting more pass money.

you can piggy back onto your injector pulse wire, I believe it is the yellow/black for the mag side injector. had the same problem a few weeks ago on a customers sled.

hello where you at??

Any quick fixes for the 2005 M7?? Has fox zero pros alround

Call him see what his side of the story is.

To bleed your brake you need to make sure you reservior is full with the cap back on the reservior pump the brake lever a few times and hold, or apply pressure while SLOWLY opening the bleeder screw until the flow of fliud stops close the bleeder first then pump the lever again and bleed etc...

Own and operate engine and transmission rebuild shop, not enough time to ride! Do alot of snowmobile repairs in the winter.

we drove 800km for the show, my brother got his truck stolen in Edmonton friday morning but the RCs found it friday night,in one piece, picked up his new M1000 on saturday! Got new klim pants ordered bca airpack, learnt a ton of good stuff. Got a pic with Krazy Canadian!!!!

built a new house last year bought a membership. bought appliances and flooring, and curtains, prices were good but takes a lot of time going through their catalogs!!! They say you can shop on the internet but thats very weak. found them to be a hassle to deal with!!! We did not have enough time...

another thing i would pull the points out and install a pertronics ingitor unit. It converts your distributer to an electronic ingition in one simple step. usually costs under $100.

If its got points it could be a 240ci specs are -points .027" -timing 6* -plug gap .035" for a 250 -plug gap .044" -timing 6* hope this helps, Dwayne

been talking to a guy from Hudson Hope who used to live in Fort Nelly hes gonna hook you up with some sledding locals!!!