Recent content by Complexd

If anyone finds a green Ortovox shovel handle in the North East corner of goat ridge bowl it’s mine lol Road Clemina yesterday, obviously conditions could be better but the bit of fresh of snow made it a bit easier to tour tour around. Good to see go see the entire zone sometimes. Sent...

Has anyone umm, scouted out east of town, across the creek… Sent from my iPhone using Tapatalk

Wrecked my throttle flapper last weekend on my 20 Khaos 800. Polaris part numbers change in 16 with the new chassis but it looks like the only difference from the pro ride is the texture/knurling where your thumb goes. Local guy has one of a 14 and as long as the TPS is happy, should work no...

Problems with the groomer? Sent from my iPhone using Tapatalk

Could be another deadly weekend if the freezing line stays low.

Yea had quite a bit of trouble with that this weekend. People parking 3-4 wide in the middle of the trail. Riding slow, weaving back and forth, and not looking back. Guess with more people in this sport than ever before you're going to have more newbies, assholes, etc but it is pretty...

Clemina was awesome today. Quite a few lines left if you like the trees. Sent from my iPhone using Tapatalk

Anyone have any updates for Renshaw today? FB page claims 60cm of fresh. Find that pretty hard to believe Sent from my iPhone using Tapatalk

Rode Salmon today. Trail in was fine. Snow was pretty good, lots of fresh lines left but was surprised how chewed up it was already. Snowing pretty hard when we came down. Sent from my iPhone using Tapatalk

Town cam has been down for quite some time yup. I'll give an in town snow report late tomorrow of Holy Smoke doesnt chime in.

Was it snowing yesterday? Claimed it was in a snowfall warning all day

Pretty sure it’s a Ridgeline Sent from my iPhone using Tapatalk

Rode Allan today. Knew it was going to be low snow but was surprised with how good it was. Found quite a bit of fresh lines. Sent from my iPhone using Tapatalk

Riderz also carries Nikwax if you're driving through working hours

What I did was take a sewing needle or close pin and heat it up with a torch and poked it through the bottom. Nice clean and small hole. Couple of my buddies drilled theirs out and it would leak oil every time we rolled it over (which was a lot lol)