Recent content by CatMan16

  1. CatMan16

    Stuck Flywheel 2013 M8

    It doesn't look like any of the magnets are missing of the outside of the flywheel. Can anyone confirm that mine are still all there. I have 3 for the inner coil and 2 for the outer coil. I can not find a picture online that show all the magnets.
  2. CatMan16

    Stuck Flywheel 2013 M8

    Greased up my puller like you suggested. Didn't have to heat anything up my garage is a bit cooler today thab it was last time I was working on it.
  3. CatMan16

    Stuck Flywheel 2013 M8

    Finally had some time this morning to work on this again. Flywheel is off and nothing looks abnormal to me. I guess I will start over testing all the switches and stator readings again. Aside from that if I still have no spark I guess it will have to go to the dealership.
  4. CatMan16

    Stuck Flywheel 2013 M8

    Thanks I will try that tomorrow.
  5. CatMan16

    Stuck Flywheel 2013 M8

    Anyone have suggestions for getting a stuck flywheel off? I have tried two different styles of pullers and had them tight enough that the threads on the puller are binding and it won't pop. I am trying to diagnose my no spark issue from last spring and need to check my flywheel magnets. I...
  6. CatMan16

    OEM Tether

    Looks like you might have to call some dealers to see who has old stock still.
  7. CatMan16

    What causes brakes to do this?

    Don't recommend that copper coat gets sticky when it is cold. Will cause other issues.
  8. CatMan16

    Humorous Kijiji Adds

    This is a good deal https://www.kijiji.ca/v-snowmobile/edmonton/2001-polaris-rmk-800-low-km/1525827685?utm_source=com.samsung.android.app.notes&utm_medium=social&utm_campaign=socialbuttons&utm_content=app_android
  9. CatMan16

    Very small electronics soldering specialist

    Sounds good. I have done more repair maintenance and assembly work than I have done design work. However I know some guys that can assist with that depending how complex of system you are looking for.
  10. CatMan16

    Very small electronics soldering specialist

    Electronic Technologist since 1996. I have soldered my fair share of circuit boards. All I need to pick up is smaller gauge solder and some solder wick. Can you post a pic of the connector? Or send me a pm and I will give you my cell number.
  11. CatMan16

    Very small electronics soldering specialist

    If you can get it to Red Deer I can fix it.
  12. CatMan16

    Noss Fuse

    3amp would likely do the job.
  13. CatMan16

    Collision repair poor quality.

    My own it was a hit and run.
  14. CatMan16

    Collision repair poor quality.

    Thanks I am waiting for a call back from the insurance adjuster.
  15. CatMan16

    Collision repair poor quality.

    Just looked over the invoice non-oem bumper cover. The next drive this thing goes on might be unoccupied over a cliff. Car was also previously repaired to the tune of $11700. Not impressed with my wifes purchase to say the least. Anyone want to hire an Electronic Technoligist I have had about...
Top Bottom