Recent content by 4Cats

Thanks,,will do

Awesome thanks guys

Hey Guys we have a 2008 M1000, 162" Sno-Pro, and it is in absolutely mint and stock condition. When on a hardpacked trail it wants to hunt from side to side and its hard to handle,,would a ski alignment fix this? Is it an inherent problem because Im on hardpack?

My onlly comment is this,,,If you hold the thottle "wide open" on anything fuel injected you will flood it...it's not the same as the old carburated models where you can hold the throttle and let the pure aire purge out the fuel,,,the efi keeps adding fuel based on the signal from the throttle...

That is pure BLASPHOMY right there. I had a 70 Challenger when I was young, and this is just wrong on all levels

This Thread is hillarious,,,,here goes,,,,I like Dodges...LOL

i doubt you will like MacKenzie,,being from a town the size of Fernie,,,,Im near Williams Lake and spent the summer working in MacKenzie,,,couldnt wait to get out,,,too small,,,cant even rent a movie from a store there

I had a local Yamaha Dealer tell me that dyed fuel screws up the injectors on the quads,,,,and this guy has built many a race sled

Right behind the Circus Circus hotel...been there done that, its a hoot,,full autos, handguns of every description, go try it

Im running a 42" Unibond lightbar on the front of my Dodge. It was $350 and is fantastic. You would think in this day and age Chrysler could figure out how to make a decent headlight

Mount it ....oh chucked in the toolbox under the seat,,,thats where mine is,,,ICBC, nor the RCMP could answer that question,,,they looked at me and giggled about the whole thing

Hey thanks for the tips,,the snow has turned to slush up here in the Interior so when we get some Ill have the wife take it for a tour, hope it is better for her. Thanks Again

I see the other hole is actually located to the rear of the hole that is in use, so I drilled this one and reloated the front arm to that spot. It tightened the track up quite a bit even with the tensioners backed right off. I also cranked some pressure onto the front shock via the spring. Did I...

Okay Guys, just checked the M1000 front of the skid inside the tunnel for the bottom holes,,,see nothing. Checked all 3 of my M1000'S no bottom holes . Should I drill holes about an inch, straight down from the current ones?

I am about to give that a try