What Did You Do In Ur Garage?
- Thread starter OVERKILL 19
- Start date
Caper11
Active VIP Member
That looks really nice niner! Well done sir.
DaveB
Active VIP Member
As a 70’s/80’s guy myself, and having owned a few big speaker systems over the years, I say ,”cool”! But being an old fart with a few Bluetooth rechargeable speakers I say,”meh”. Lol.
doorfx
Active VIP Member
Those aren’t my big ones, they are coming lol
Go-Vertical
Active VIP Member
Absolutely
doorfx
Active VIP Member
Brought home some big power lol
Luke The Drifter
Active VIP Member
A change in careers brought home my toolbox. I still have to reconfigure my shelving to put it against the wall properly but that’s another night
freeflorider
Active VIP Member
i never seen a Lamborghini with drawers before... oh it’s a tool cabinet, well looks just as nice and cost about the same to I’m guessing.
Caper11
Active VIP Member
Thats a nice setup! Congrats on the new career, What are you doing now that yah get to take that home???
Luke The Drifter
Active VIP Member
Thanks. I’m a journeyman HET by trade, got into management a few years ago and I’d still help out on the floor when the guys needed a hand and it was busy. So my tools stayed at the shop. I’m going to be looking after an fleet of equipment with my new gig. I’ll still do the odd small repair/service here and there so I may be taking it back once we setup with a shop. Either way it’s so nice to have all my tools at home for now. I can’t count the amount of times I’d be on a project at home and think “crap, I have what I need at the shop”. And then reluctantly go buy it at Ukrainian tire
DaveB
Active VIP Member
Took front left Leveleg off the moho today. I over-extended it about 3 yrs ago leveling the rig in a very off camber spot and broke a shear pin in it. Fixed the pin, but it’s never been right....fails on retract mode about 50% of the time. Gotta turn off the panel, hit retract again...sometimes 3-4 times to get it sucked back up.
ANYWAYS...pulled er all apart. Cleaned brushes and commutator. Threw a straight edge on the inner extendable leg: slight (very) bend. Took the flapper wheel to the high spots, re-greased. All seems OK. Fingers crossed.
ANYWAYS...pulled er all apart. Cleaned brushes and commutator. Threw a straight edge on the inner extendable leg: slight (very) bend. Took the flapper wheel to the high spots, re-greased. All seems OK. Fingers crossed.
papajake
Active VIP Member
Washed the sxs and drank beer getting ready for rocky jamboree
DaveB
Active VIP Member
Changed oil in the JD F725, greased, took all guards off and cleaned grass out, blew out air filter. Good for another year.
DaveB
Active VIP Member
Does this look like 80 bucks?
Rbrduk
Active VIP Member
doorfx
Active VIP Member
Nope $25 tops
Go-Vertical
Active VIP Member
DRD
Active VIP Member
Trying to keep water on the water side and oil on the oil side.
scottp
Active member
PI intake swap on my 98 Mustang
Similar threads
