 |  |  |
| | |
|
Discuss APEX - Error Code 46 in the SNOWMOBILE BRANDS FORUM forums; Pulled my 07 APEX out of storage and I'm getting a Code 46 on the display Check the Fault Code ...
| ||||||
  |
| | LinkBack | Thread Tools | Display Modes |
10-21-2009, 06:54 PM
| #1 (permalink) |
| Member   Join Date: Oct 2007 Location: Saddle Hills, AB
Posts: 617
Casino Cash: $486084 Thanks: 219
Thanked 284 Times in 172 Posts
  | APEX - Error Code 46 Pulled my 07 APEX out of storage and I'm getting a Code 46 on the display Check the Fault Code Guide & It Says: Fault Code # 46 ITEM = Vehicle System Power Supply (Monitor Voltage) SYMPTOM = Power Suppy to FI System Is Not Normal Fail Safe Action = Output To Grip Warmer Is OFF Able / Unable To Start = ABLE Able / Unable To Drive = ABLE Check Voltage at Boost Leads Running = 17.44 Off = 14.52 Does not seem right, but I do not have a shop manual. Anybody know what it is suppose to be? Thanks |
|  |
| Sponsored Links, Plese click on Banner to View there Website | |
|
10-22-2009, 04:34 PM
| #2 (permalink) |
| Member   Join Date: Aug 2008 Location: Ponoka
Posts: 155
Casino Cash: $221220 Thanks: 42
Thanked 83 Times in 51 Posts
| Re: APEX - Error Code 46 Originally Posted by koby I would have guessed your battery was hooped, but if your getting over 14 volts then it should be ok. try a trickle charge on it for a day then restart. I had that code once after I hit a cornice and broke the plug off my voltage regulator, but i probably wasn't getting over 17 volts running either.
|
|
| |
|
10-22-2009, 06:20 PM
| #3 (permalink) |
| Member  Join Date: Dec 2006 Location: Calgary
Posts: 294
Casino Cash: $410868 Thanks: 83
Thanked 51 Times in 41 Posts
| Re: APEX - Error Code 46 Both voltages seem high to me but 17.44v especially. The only time I've ever seens anything greater than 15v on a 12v system was a blown battery. I'd load test the battery or check the voltage regulator & connections. Not running the battery should read 13.2v (or there abouts if fully charged). I would expect to see running voltages of about 14 - 15v. good luck, Shawn.
__________________ Calgary Snowmobile Club Member Crow Snow Riders Club Member 06 Yami Apex Mtn 08 Yami Phazer Mtn 94 Yami Bravo 01 Poo 120 |
|
| |
|
10-22-2009, 08:55 PM
| #4 (permalink) |
| Member Join Date: Oct 2007 Location: Saddle Hills, AB
Posts: 617
Casino Cash: $486084 Thanks: 219
Thanked 284 Times in 172 Posts
| Re: APEX - Error Code 46 Originally Posted by shawnmcgr This is what I was hoping to hear. I will replace the battery with a new fully charged battery and post the results.
Thank you |
|
| |
| Sponsored Links, Plese click on Banner to View there Website | |
|
10-27-2009, 11:22 AM
| #5 (permalink) |
| Member Join Date: Oct 2007 Location: Saddle Hills, AB
Posts: 617
Casino Cash: $486084 Thanks: 219
Thanked 284 Times in 172 Posts
| Re: APEX - Error Code 46 Installed new battery and same code. It was oil change day Saturday, so while wifey's Phaser was apart I borrowed her voltage regulator. After a minute of idle the code cleared. My new reg will be in tomorrow. |
|
| |
| |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| error code | dean_jimmy96 | YAMAHA | 5 | 02-20-2009 09:24 PM |
| apex engine code | yamaha apex | YAMAHA | 3 | 01-08-2009 06:41 PM |
| Code reader | Linkz | JUST ABOUT ANYTHING GOES | 0 | 02-21-2007 10:19 PM |
| All times are GMT -6. The time now is 12:37 AM. |
 |
Copyright © 2006 - 2009 SnowandMud.com
|  |
Linear Mode
