07 motors

Burnster · 11-11-2009, 08:59 AM

Looking at some 2007's. What's up with the motor issue.

hpjunkie · 11-11-2009, 11:29 AM

Some had crank issues, as did some of the 08's. Too tight on center bearing, traditionally if it has 1000km you should be ok. Always a good idea to check run out with a dial indicator, BRP spec is .002. Most new cranks need to be trued, but people often assume since it's new, it must be good.

11-11-2009, 08:59 AM	#1 (permalink)
Burnster Member Join Date: Feb 2009 Location: Rocky Mountain House Ab. Posts: 12 Casino Cash: $25400 Thanks: 0 Thanked 2 Times in 2 Posts	07 motors Looking at some 2007's. What's up with the motor issue.

11-11-2009, 11:29 AM	#2 (permalink)
hpjunkie Member Join Date: May 2009 Location: High Prairie,AB. Posts: 12 Casino Cash: $71700 Thanks: 0 Thanked 4 Times in 4 Posts	Re: 07 motors Some had crank issues, as did some of the 08's. Too tight on center bearing, traditionally if it has 1000km you should be ok. Always a good idea to check run out with a dial indicator, BRP spec is .002. Most new cranks need to be trued, but people often assume since it's new, it must be good.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
2 cuttler 1000 motors	STRAYPUSSY	Engine/Engine Parts	4	01-23-2010 09:37 PM
1920's Armstead Snow Motors Promo Movie	2003Summit	JUST ABOUT ANYTHING GOES	4	03-03-2009 09:09 PM

Sponsored Links, Plese click on Banner to View there Website