- Thread starter
- #241
gunner3006
Active VIP Member
Flapper disk for the win. Heading to the welder for the bed mods lol. Then I’m going to hit it with the liner spray.
WeldCraft Jet
- Thread starter gunner3006
- Start date
Flapper disk for the win. Heading to the welder for the bed mods lol. Then I’m going to hit it with the liner spray.
High Velocity
Active VIP Member
Dual clamp tensioning screws should be 180* apart.
- Thread starter
- #243
gunner3006
Active VIP Member
New throttle installed and hooked up. Pulled my window out to mount the two side bolts. Ripped my gasket
. New gasket coming. Started making the doghouse more usable and into a bed when needed.- Thread starter
- #244
gunner3006
Active VIP Member
Almost ready for the line-x. Fit it up tomorrow then work on a bed system for it.
- Thread starter
- #245
gunner3006
Active VIP Member
"The judge"
New member
What size f kicker 9.9?? What length would f leg?? How much??
neilsleder
Active VIP Member
Totally looking for a kicker. But also looking for a job so kicker won’t be happening
- Thread starter
- #248
gunner3006
Active VIP Member
No worries buddy. I sold er. I loved that kicker. My problem with it was it was heavy. With hydraulic tilt and all the controls that made it not portable, I was ready for a change. So I’m going to a 6 hp merc or tohatsu. There actually the same motor. But we will see what pops up. I have to get the boat back up to sexsmith for a cover. Can see the light at the end of the tunnel now. Just need some nice weather.
pfi572
Active VIP Member
Told you it looked heavy ?!! Now the truth comes out ?
Caper11
Active VIP Member
Told you it looked heavy ?!! Now the truth comes out ?
Well it did say Yamaha on it.
- Thread starter
- #252
gunner3006
Active VIP Member
Is it portable Clode? I don’t want mine on all the time.
- Thread starter
- #254
gunner3006
Active VIP Member
This is the one I’m looking at right now.
I used it last summer, worked great for trolling, sips fuel, and is not super heavy
- Thread starter
- #256
gunner3006
Active VIP Member
Well that’s good to hear. I have the line for fuel that’s still run out to the kicker plate for the Yamaha from my main tank. It tilts up high enough when your driving ?
with my Ali-craft outboard mount when I am in travel mode I swivel it onto the swim grid. The leg goes into a rubber v-block and I bungie cord it. It tilts a lot.
- Thread starter
- #258
gunner3006
Active VIP Member
Right on. We’re did you buy yours from? Was it new or used?
new, from my local dealer Trail Blazin Power
- Thread starter
- #260
gunner3006
Active VIP Member
Similar threads
