Sport jet parts.

neilsleder

Active VIP Member
Joined
Oct 18, 2009
Messages
9,618
Reaction score
16,999
Location
Leduc Alberta
Tried an exact welding 3 blade impeller this weekend. Total junk! Anyway long story short it made some cavitation damage way worse and now my stator has a hole in the side. Any body know where to find a used stator?
 

pfi572

Active VIP Member
Joined
Mar 10, 2010
Messages
6,063
Reaction score
15,236
Location
Grande Prairie
That sucks about stator.
Yes that impeller isn’t what they tell you it is that’s for sure.
Rock busted stator I take it?
 

NoBrakes!

Active VIP Member
Joined
Nov 13, 2011
Messages
6,002
Reaction score
11,802
Location
Edmonton
Whats the claim to fame for the 3 blade? how about the Hi Skew stuff?
 

neilsleder

Active VIP Member
Joined
Oct 18, 2009
Messages
9,618
Reaction score
16,999
Location
Leduc Alberta
Whats the claim to fame for the 3 blade? how about the Hi Skew stuff?

Supposed to be better whole shot and lower cruising rpm. I got way worse hole shot and no top speed. 4 blade hi skew 40mph 3 blade 28mph! And the blades of the 3 blade go right to the stator and don’t allow the small rocks past and beat the sh!t out of the stator. Not happy!
 

pfi572

Active VIP Member
Joined
Mar 10, 2010
Messages
6,063
Reaction score
15,236
Location
Grande Prairie
Neal they have a stainless stator protection piece you might be able to use ?
 
Last edited:

neilsleder

Active VIP Member
Joined
Oct 18, 2009
Messages
9,618
Reaction score
16,999
Location
Leduc Alberta
Neal they have a stainless stator protection piece you might be able to use ?

I seen those I think they would work sweet.
7254b7ae21f1863b7c3e05e4ead5cc08.jpg

But mine has cavitation damage. A hole right through the side!
 

neilsleder

Active VIP Member
Joined
Oct 18, 2009
Messages
9,618
Reaction score
16,999
Location
Leduc Alberta
It was bad when I bought the boat. The guy that had it before me had the 3 blade in for a long time and did lots of damage. Must of been ready to go through then this weekend just finished it off.

I rebuilt that stator in the picture
 

174mcx

Active VIP Member
Joined
Dec 2, 2009
Messages
367
Reaction score
1,160
Location
rocky mountain house
Ok I will try, that will be cast hey? so there is some alloys there doesn't weld perfectly I imagine? any help would be appriciated, I'm fairly new to alum welding.
 

neilsleder

Active VIP Member
Joined
Oct 18, 2009
Messages
9,618
Reaction score
16,999
Location
Leduc Alberta
Well got it welded got the smallest torch set up I could at work and got in there just enough!
 

neilsleder

Active VIP Member
Joined
Oct 18, 2009
Messages
9,618
Reaction score
16,999
Location
Leduc Alberta
Ok I will try, that will be cast hey? so there is some alloys there doesn't weld perfectly I imagine? any help would be appriciated, I'm fairly new to alum welding.

Sport jet parts weld really good! Welded them lots now even pump housings and all have lasted. Just clean it good!
 
Top Bottom