Hey guys I just upgraded my 10 yr old to a CR85 from a KX65. On his very last ride on the kx he dented the pipe and I really don't want to buy a new pipe since he won't be riding it anymore. Tried using air pressure and heat to pop the dent out but the rubber just popped from the heat. Anyone know of anywhere that fixes 2 stroke pipes in or around Edmonton relatively cheap. Thanks in advance for any info.
Dent in 2 stroke pipe.
- Thread starter DDrake
- Start date
Potato_Gun
New member
You might try a local auto body shop. They have tools available for pulling dents in sheet metal.
Iamcatman
Active member
I have heard of some people filling the part of the pipe with water, and putting it in the freezer. pushes the dent out, but chance of cracking a seam. just my 2C
senorjeem
Active VIP Member
I wonder if you stick a welding rod on it (wire feed at too low amperage) and then heat it cherry with a torch, if you could use that stuck on wire to pull the dent out. Might need several wires.
slededjr
Active VIP Member
You need a uni spotter. Auto body shop tool that spot welds studs on to metal to pull dents. I have one but I'm swamped for the next few weeks. Unless you're not in a hurry.
007sevens
Active VIP Member
when I seen the title to this thread I really thought you had different problem. 
- Admin
- #7
Go see Neil at Neils Power Pipes in Winterburn, Hes a vendor on here. Great guy, can do anything with pipes.
neilsleder
Active VIP Member
Or call cycle works south and see if Milan still works there. He can get dents out of pipes he also builds them.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
csharko
Active member
Plug both ends one solid with a rubber stopper with a metal strap the other end with a rubber stopper with a air chuck and a flat strap, clamp the strap around the end of the pipe, put 5 pounds of air in it heat the dent up with a torch and it pops right out, I had done this lots on my two stroke pipe the only down fall is it discolour's the pipe where it is heated, just be careful to not heat it up to much or put to much air in it.
new24stroke
Active VIP Member
I took a big dent out of my kids cr125 pipe .i plugged both ends and pressured it up. How ever I couldn't get enough heatom a propane torch . I had to go to the shop and use the oxy. Popped out with in less then a minute
Similar threads
