Stretching Track to 162 2.6 vs 3

Dawizman

Active VIP Member
Joined
Feb 24, 2014
Messages
2,821
Reaction score
9,991
Location
Cold Lake, AB
I'm looking at upgrading the track on my 2015 m8000 SnoPro Limited 153x2.6.

I want to go up to a 162. As I understand, I should be able to just replace the rails, and put the new track on.

I'm stuck between the 2.6 and the 3inch power claw tracks. As I understand, I should be able to fit the 3" with the factory 8 tooth drivers, but it would fit and run better if I flip out to 7 tooth drivers due to clearance, compressor effects, etc...

Would I need to gear up with the new drivers?

Also, what's the consensus on 3" vs 2.6"? Anyone regret the 3"? Is it a big improvement? Does it suck in certain snow conditions?

If I went with the 2.6, I would likely trim the small fingers off, making it basically the same paddle layout as the 3" and dropping 3lbs of rotating mass. Any downside to that?

I ride in all conditions, not always fresh powder, which is why I'm on the fence.
 

2010m8

Active VIP Member
Joined
Dec 4, 2009
Messages
298
Reaction score
420
Location
leduc
If your riding all types of conditions I would stick with the 2.6 and leave the fingers on. They will help traction on hard pack. Go with 7 tooth if you do go 3”. Clearance will be to tight and more likely to cause damage to the cooler if something makes it way that far back.
 
Top Bottom