Need new bars for my 2014 m8000

1968chevy

Active member
Joined
Dec 15, 2008
Messages
36
Reaction score
0
Location
VEGREVILLE AREA
My hanlde bars and all the controls except the brake on my 2014 M8000 got wrecked and need to replace. OEM are prices are insane! I like the Polaris bars has anyone else put on different bars on?
 

tyman212

Active member
Joined
Mar 5, 2013
Messages
56
Reaction score
39
Location
Camrose Alberta
Im just replacing the stock bars. Going with CFR rooster bars. Very close to the same bend and width as stock. I already got rid of the factory switch blocks.
 

bgraff1

Active VIP Member
Joined
Oct 30, 2010
Messages
190
Reaction score
340
Location
Lloydminster Alberta
CFR bars for sure. I deleted the whole factory setup. went with CFR bars and risers, deleted hand warmer block and installed an RSI throttle block with integrated kill switch and new reverse switch. bars are nice and clean, much better than stock
 

AGGRESIVEZEBRA

Active VIP Member
Joined
Dec 1, 2014
Messages
399
Reaction score
434
Location
Edmonton
The roster bars are close to stock. If you want a riser bar there are a few options. If you get a riser bar keep in mind you will probably need new risers aswell. As for controls take a look at then speedwerx control kit. Gets rid of all the bulk on the bar. Echo cycle has them in stock currently.
 
Top Bottom