M8000 Exchanger.

dev870

Member
Joined
Dec 23, 2013
Messages
8
Reaction score
2
Location
DV
I hit a steel angle iron rod under the snow and tore a massive hole in my exchanger. It then went through my track and wiped out some skid parts. How do I go about changing it out?
It looks like there are a few rivets. Is a zip disc or drill the answer for those? Are there special tools required to pull drive cog out?
 

AGGRESIVEZEBRA

Active VIP Member
Joined
Dec 1, 2014
Messages
399
Reaction score
434
Location
Edmonton
If you dont care about the item your cutting the rivets off zip disk is much easier but less precise. drill will not damage the item your taking the rivets out of but takes much longer. drive cog is just basic tools. Cir-clip pliers make life easier but not necessary.
 
Top Bottom