Tunnel extension

buckie · Dec 17, 2014

Hey guys im lookin to update my tunnel on my m1000 to the newer tapered style over the ugly wide end with the godly plastic, been lookin at the vei, cr, thin air, and slp sections anyone have good or bad experiences with any of them? Just want something strong and beter looking, thanks

suzuki_ryder · Dec 17, 2014

The factory one from 09+ should be easy to install.
The cooler is different though so you'll need that as well.

Sent from my iPhone

Bnorth · Dec 17, 2014

BDX makes a kit that turns yours into the new style.

buckie · Dec 17, 2014

suzuki_ryder said:
The factory one from 09+ should be easy to install.
The cooler is different though so you'll need that as well.

Sent from my iPhone

From what ive been reading the 09 and up are different somehow all companies have a seperate listing from the 05-08? They look the same?

suzuki_ryder · Dec 17, 2014

Ohh sorry then. I'll just keep quiet in the back. Lol. I figured they would fit with minimal work. I do know the coolers were different in the back, and the running boards are different where they mount.

Sent from my iPhone

buckie · Dec 17, 2014

suzuki_ryder said:
Ohh sorry then. I'll just keep quiet in the back. Lol. I figured they would fit with minimal work. I do know the coolers were different in the back, and the running boards are different where they mount.

Sent from my iPhone

Im trying to figure out if its just the difference in the coolers, you could very well be right cause every pic ive dug up looks the same where they mount up

CatMan16 · Dec 17, 2014

I converted my 08 to the newer cat tunnel. You will need the new cooler and tunnel supports and a couple of 90 degree hoses to connect the cooler. All the rivet holes line up perfectly. As long as you don't screw up like I did and cut you foot rails too short you won't need new ones.

gibsons · Dec 17, 2014

I put the V.E rear tunnel section on two of my sleds , super easy, and the V.E rear bumper on another. I reused my coolers, just had to flatten them in a press, and picked up some silicon coolant line from greggs since they were the only place that sold the odd ball size. If you want to keep your cost down order there rear bumper then you only have to cut the taper in your rear tunnel, plus order the cap for the back section of the tunnel and there little LED light.

Tunnel extension

buckie

Active VIP Member

suzuki_ryder

Active VIP Member

Bnorth

Active VIP Member

buckie

Active VIP Member

suzuki_ryder

Active VIP Member

buckie

Active VIP Member

CatMan16

Active VIP Member

gibsons

Active VIP Member

Similar threads