how to weld crank? aslo what else should i do while its split?

d2therick

Member
Joined
Dec 3, 2013
Messages
8
Reaction score
2
Location
hailey idaho
just wondering how to weld the crank on a 1m. does anyone have any pics tip and tricks? also is there anything else I should do while I have the bottom end split?
 

ippielb

Active VIP Member
Joined
Mar 4, 2011
Messages
1,910
Reaction score
3,274
Location
SE Saskatchewan
Website
www.youtube.com
just wondering how to weld the crank on a 1m. does anyone have any pics tip and tricks? also is there anything else I should do while I have the bottom end split?
you get the crank true as close as you can, and then weld the pins to the webs. Then after welding check for true again, and hammer it out back to zero or as close as you can get it. But before you do that, replace the inner crank bearings/seals, once you weld it, you wont be able to split the crank unless you go to town on it. Just trying to true the crank can be a headache in itself if you aren't properly set up.
BansheeCrank1.jpg

BansheeCrank2.jpg
 
Last edited:

DRD

Active VIP Member
Joined
Oct 21, 2008
Messages
2,725
Reaction score
5,380
Location
Red Deer County
just wondering how to weld the crank on a 1m. does anyone have any pics tip and tricks? also is there anything else I should do while I have the bottom end split?

Not to sound like a dick but if you have to ask you would be best to send it out where they have the jigs and expertise.
 

BDF#900

Active VIP Member
Joined
Sep 30, 2007
Messages
710
Reaction score
484
Location
High atop a hill
if your doing an oil injection delete there is a spot you need to drill a hole in the cases to allow lube to drip on the gear for the water pump.
 
Top Bottom