03 1m 900 clutching help

sledder92

Member
Joined
Nov 4, 2013
Messages
10
Reaction score
0
Location
south cooking lake
I have a 03 1m 900 its stock except for cpi single pipe v force reeds and the clutch was upgraded to a newer cat 6 tower instead of the 9 that it would of had in 03. Im running it at 2000 ft and it's only pulling 7350 for top rpm. Both clutches seem to be in good working order secondary has red spring and is on 3rd setting. Primary has yellow and green spring and It has 65 gram weights right now but from what I could find out I should be running 74 gram weights with the pipe so im way off right now. But it should be over reving with the lighter weights and it's not even hitting top rpm. Is it possible that I have a problem with the power valves or something?
 

Ancient Sledder

Active VIP Member
Joined
Feb 21, 2008
Messages
675
Reaction score
95
Location
Onoway Alberta
I can tell you from experience that with the power valves stuck closed it will still go to full RPM. With the valves working properly, it still goes to full RPM, but with about 20 more HP.
 

TROLLCAT

Active VIP Member
Joined
Nov 23, 2010
Messages
69,304
Reaction score
37,821
Location
Dease Lake BC
I have a 03 1m 900 its stock except for cpi single pipe v force reeds and the clutch was upgraded to a newer cat 6 tower instead of the 9 that it would of had in 03. Im running it at 2000 ft and it's only pulling 7350 for top rpm. Both clutches seem to be in good working order secondary has red spring and is on 3rd setting. Primary has yellow and green spring and It has 65 gram weights right now but from what I could find out I should be running 74 gram weights with the pipe so im way off right now. But it should be over reving with the lighter weights and it's not even hitting top rpm. Is it possible that I have a problem with the power valves or something?

me thinks your yellow green spring wore out get your self a yellow white spring and try that
 
Top Bottom