pfi572
Active VIP Member
Probably just unhooked to show how if or it can happen ?
Hey ? I have a idea ? Let’s put a shorter tunnel on ?
Call it a ??
Stuff to watch for on the 18+ cats.
- Thread starter skegpro
- Start date
Probably just unhooked to show how if or it can happen ?
Hey ? I have a idea ? Let’s put a shorter tunnel on ?
Call it a ??
FernieHawk
Active VIP Member
Puerto Rican special ...
Shitfly
Active VIP Member
Have seen, and have been hearing more about lugs splitting/cracking on some Alpha tracks (165" tracks for sure), similar to some of the Doo 850's when they came out couple years ago. Seems to be about an 1-2" from the inside of the lugs and are cracking/splitting from the tip of the lug to nearly the bottom of the lugs (where the mono rail edge is and track flex occurs) Thought I'd see if there is any people on S&M here with this issue and what they have heard from Cat//Textron and/or your dealers? Sounds like it's showing this issue around the 800km+ mark..
I have 1950 k on my Alpha have a couple of rips in lugs.The paddle's are very soft in the middle section and will tear if you dig down to **** below which i have done.Stay in deep snow and there fine.I did repair my damage with some glue and a small piece of inner tube over top of rip.
tex78
Active VIP Member
Push on the outer side of the track
It cracks just in the outside of the rear rail wheels right through the lug
Will do every lug, both sides in no time
1900km on Alpha, track is fine, hyfax is fine. I've done a few full speed runs on the trail. Steering post bushings are getting a little sloppy. I've drained the chaincase four times. The oil always looks like death because of the aluminum gear. I think I'll change it to steel.
LBZ
Active VIP Member
Where are folks getting this steel gear from?
ippielb
Active VIP Member
- Joined
- Mar 4, 2011
- Messages
- 1,912
- Reaction score
- 3,278
- Location
- SE Saskatchewan
- Website
- www.youtube.com
ECU heatshield cracked and broke off a tab, rattled like crazy, removed ear, bent out the mount and put the screw in to grab the edge.
Plastic on edge of mesh screen broke. No idea how, never hit anything never or nothing.
Sliders have a strip taken out from clips yet again. Debating on trying to get the track fully clipped to prevent this from happening.
Plastic on edge of mesh screen broke. No idea how, never hit anything never or nothing.
Sliders have a strip taken out from clips yet again. Debating on trying to get the track fully clipped to prevent this from happening.
MP Kid
Active VIP Member
LBZ
Active VIP Member
$75 vs $1000 for one.........
What he said. And l worry that if there was an engine problem and they saw the alternative oil tank it might be an excuse to deny warranty.
Did you just change the bottom gear?
yes, there was no wear yet on the top sprocket, I had 500miles on it. The aluminum gear was looking ugly and I was sick of changing the oil every few rides to remove the aluminum contamination.
I went with the belt drive but had parts dealer installed.....probably not matter since I have changed out several other parts also, oh well.
Going trade out some aluminum and steel for some carbon fibre parts this summer for early season testing.
My warranty is likely screwed.
LMLCHEVY
Active VIP Member
Is everyone peeling all the foam off their panels on these?
I always do yes, especially on the clutch side as I find the foam holds moisture
Similar threads
